GuitarCountry

Lesson 5 of 9 · Beginner · 10 min

How to read tabs and chord charts

Guitar tablature, chord diagrams and chord charts explained in five minutes, no music-reading needed.

Guitar accessories on a wooden table: a strap, clip-on tuner, capo, picks, cable, strings and a cloth

You don't have to read sheet music to learn guitar. Most guitarists use three simpler tools.

1. Chord diagrams

A picture of the fretboard standing upright. Strings run top to bottom (low E on the left); frets run across. Dots show where to press, numbers show which finger. See our chord library for examples you can hear.

2. Tablature (tab)

Tab shows single notes and riffs. It has six lines, one for each string, with the thin high E string on top, the opposite of what many beginners expect. Numbers tell you which fret to play on that line.

e|-----------------|
B|-----------------|
G|---------0-------|
D|-----0-2---2-0---|
A|-0-2-------------|
E|-----------------|

Read left to right. In this example you play the open A string, then the 2nd fret of A, then the open D, and so on. Numbers stacked on top of each other are played together.

Common tab symbols

  • h hammer-on: pick a note, then "hammer" a finger down to sound a higher note without picking again.
  • p pull-off: the reverse, pulling a finger off to sound a lower note.
  • / and \ slides up and down.
  • b bend: push the string to raise the pitch.
  • x a muted, percussive note.

3. Chord charts

A chord chart shows the chords and the bars. Our song pages use this style:

| G | G | C | G | D | D | G | G |

Each box between bar lines is one measure. In 4/4 time, that's four beats. Strum your pattern through each measure, then change to the next chord.

Most tabs online leave out rhythm. Listen to a recording of the song while you read so you know how long each note lasts.

Updated November 19, 2026.